I was all ready to replace a leaking temperature and pressure relief valve on my hot water tank.
After doing the yearly check of the valve to see if it works (actually i've never checked it before) it wouldn't stop dripping.
It probably had something to do with all that corrosion on the inside of the valve.
Everyone said that you have to turn off the water, drain the tank, then replace the valve.
But i didn't want to do that, so i keep flipping, pushing, pulling on the valve and tried to get it to seat properly with the gasket.
Finally after a couple days the drips stopped. So just keep flipping and slapping that valve until whatever is causing the drip gets dislodged.
No comments:
Post a Comment